
NAV Series TCP/IP Standalone Network Access Controller
34
4.7.4.3 Alarm Output Time Setup
TheAlarmSettingcansetthealarmwithphysicalinput,aswellasthealarmoutputtimeof
illegalevents,suchastheunknowncard,invalidcard,expiredcard,invalidtime,invaliddoor
region,etc.
Inthesubmenuofthe“AlarmSetting,”scrolltoselectthe“AlarmActionSetting”menuitem
and press “#” to enter the submenu to set the alarm output time. The submenu has 11
menuitems,includingSYSPINFail,ARMPINFailAlarm,RemoteAlarmOut,UnknownCard,
ExpireCardAlarm,InvalidCardAlarm,InvalidTimeAlarm,CardPinFail,ForcedOpenAlarm,
HeldOpenAlarm,andPeanicOpenAlarm.Scrolltoselectthecorrespondingalarmevents
andAlarmActionSettingforthecorrespondingevents.
Forexample,incaseofsettingtheSYSPINFail,inthesubmenu,scrolltothe“SYSPINFail”
menuitemandpress“#”toenterthealarmtimesetting
interface.Alltheoutputsofalarm
events are latched modes and their settings are similar to the physical alarm input time
setting.
ThesettingstepsofotheralarmeventsarethesameasthoseoftheSYSPINFailSetting.
4.7.5 Address Setting
Theaddressisuniquewhich cannot be assignedtoothercontrollersin thesamesoftware
system.
Inthesystemmainmenu,scrolltothe“AddressSetting”menuitemwithnumericalkey“2”
or“8”andpress“#”toenterthismenuitem.
larm Time
000 Min 10 Sec
Cancel OK
Forced Open Alarm
Held Open Alarm
Peanic Open Alarm
ExpireCard Alarm
Invalid Card Alarm
Invalid Time Alarm
Card Pin Fail
SYS PIN Fail
ARM PIN Fail
Remote Alarm Out
Unknown Card
Comentarios a estos manuales