
NAV Series TCP/IP Standalone Network Access Controller
35
Input 4 digits in range of 0000~9999, and Press “#” to confirm and the setting will tak e
effect.Press“*”toexitwithoutapplyingthesettings.
4.7.6 Set Network
Inthesystemmainmenu,scrolltothe“SetNetwork”menuitemwithnumericalkey“2”or
“8”andpress“#”toenterthismenuitem.Inthesubmenuitems,scrolltoselectIPAddress
Setting,GatewaySetting,NetmaskSettingandDNSSetting.
4.7.7 DHCP Setting
Scrolltothe“DHCPSetting”menuitemandpressfunctionkey“#”ornumericalkeys“5”or
“6”toenterthesettingmenu.
Press “#” key to switch between “ON” and “OFF”. Press “*” to confirm the DHCP status
settingandexit.
IfDHCPisON,itwillgetanIPaddressaftercontrollerconnectedtointernet.
4.7.8 IP Address Setting
Scrolltothe“IPAddressSetting”itemandpressthefunctionkey“#”ornumericalkeys“5”
or“6”toentertheinterface.
InputtheIPaddresstobesetandpress“#”toconfirm.Press“*”toexit.FactorydefaultIP
IP:
___.___.___.___
Cancel OK
DHCP Setting:
OFF
[#]To toggle
DHCP Setting
Set IP Address
Reset Network Setting
Address:
0000
Cancel OK
Comentarios a estos manuales