
32
3232
32
Erase All Events
The controller will record all events that occur, beginning immediately upon powering on.
These events can be purged by following the instructions below. If the controller is never
connected to a PC, then old records will be automatically overwritten when storage space is full
(40,000 events max.).
Under the System Setting Menu, press at the window below to erase all events.
LCD will prompt the user to confirm the action:
Pressing will result in all events being permanently erased.
Restore Factory Settng
This function is used to reset all settings to factory set default values.
Under the System Setting Menu, press at the window below to reset all settings.
The LCD will prompt the user to confirm the action. Press to confirm and perform the
reset action.
User Setting
User setting can be configured using either the fingerprint controller or the EverAccess Flex
Series software. Adding new user on Flex software requires an additional fingerprint USB
reader (not included in the package). To configure users from the fingerprint controller, the
steps are described as below.
Enter User Setting Menu
User setting is under system setting menu. Press button once to bring it up:
User Settin
User SettinUser Settin
User Setting
gg
g
Are You Sure?
Are You Sure?Are You Sure?
Are You Sure?
[ENT] to Confirm
[ENT] to Confirm[ENT] to Confirm
[ENT] to Confirm
Restore Factory
Restore Factory Restore Factory
Restore Factory
Default
DefaultDefault
Default
Are You Sure?
Are You Sure?Are You Sure?
Are You Sure?
[ENT] to Confirm
[ENT] to Confirm[ENT] to Confirm
[ENT] to Confirm
Erase All Events
Erase All EventsErase All Events
Erase All Events
Comentarios a estos manuales