EverFocus EBC890 Manual de usuario descargar pdf (Pagina 17)

Fig. 5. Common Door Configuration for Fingerprint Controller

As the

Fig. 5 shows, the fingerprint controller will first work as a controller that receives inputs

of door lock, door sensor, request-to-exit. Also the built-in reader in the fingerprint controller

will sense the presented cards. No additional entry reader is needed. An exit reader can be

installed depending on the actual requirement and connected to the fingerprint controller. The

fingerprint controller can be further to be networked with more flex controller or connect to

computer.

Determining System Structure and Components

Determine how many flex controllers and fingerprint controller are needed, and whether

an Ethernet interface is required.

1. Each EverAccess controller can accommodate up to 8 card readers. If the system

to be installed requires more than 8 readers, additional controllers are necessary.

These controllers can be connected to the system as described in chapter 4.

2. The fingerprint controller can support 2 readers (one built-in, one additional) on

one door. Also it can network with other Flex controllers.

3. If one or more controller is to be installed at a different location than the system

computer is to be installed, an Ethernet interface is required to connect over the

internet. An Ethernet interface may also be used in locations at which the

controllers are installed a long distance away from the system PC. Please refer to

chapter 4 for more details on installing the Ethernet interface.

Fingerprint

controller

Door

Sensor

Door lock

Additional

Power Supply

EXIT

V+

Request

exit

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 63 64

Sin comentarios

EverFocus EBC890 Manual de usuario Pagina 17