EverFocus EBC890 Manual de usuario descargar pdf (Pagina 15)

Fig. 3. Installation Overall Steps

1. One reader, basic access control

The most basic configuration involves one card reader and an electric strike. In

this configuration, a person presents a card to the reader, and is either granted or

denied access. The electric strike unlocks if the system grants access. Another

variation of this scenario involves setting the system up to monitor whether the

door is open, which allows the system to protect against propped open doors, or

doors being held open for too long.

2. One reader, with request to exit device

Step 1: Preparing for the Installation

• Obtain a floor plan

• Determine the hardware and location

• Determine the number of controller and

modules and system architecture

Step 2: Hardware Installation

• Mount the controller and enclosure

• Install and connect the card readers

• Connect the electric strikes or mag locks

• Connect the controller to the system

computer and desktop reader

• Mount a backup battery in the enclosure

Step 3: Software Setup/Configuration

• Install the software in the control computer

• Setup the user accounts who will use the software

• Configure the controller and all other hardware settings

• Configure the holidays, access group and the door control

schedule

• Enroll the cards and set the cardholders’ properties

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 63 64

Sin comentarios

EverFocus EBC890 Manual de usuario Pagina 15