EverFocus EBC890 Manual de usuario descargar pdf (Pagina 59)

5151

Setup the User Accounts for the Software

User

of Flex series access control software is a person who operates the software at any user

interface. Each user belongs to a certain authority group. The authority group defines the

authority level of users over the operations in the software. Different authority groups have the

different access to the operations in the software.

The first step to use the software is to setup a user list that defines who will be able to use the

software, and assign the authority group to each user. This user name and the password will be

required to login the software.

Please note that a user in admin group is required to configure all the other settings.

For the details to setup a user account, please refer to the software manual.

Configure the Controller and All Other Hardware

In this step, users need to set all the configurations for the controllers, doors, readers and

alarms. All these configurations are closely related to the hardware. The rough sub steps are as

below:

1. Add a controller to the system

Go to the controller configuration dialog box in the software. Click the ‘add’ button,

give the RS485 address for the controller, set the serial port for the controller and click

the submit button to connect a controller.

If the wiring is correct and the address of the controller is valid, the software should be

able to find the controller and show the status of the controller as ‘online’. This

indicates that the controller has been added to the system.

2. Configure the door settings

Door name, door open time and door held open time should be configured in this step.

Door name is used to help users remember the door location and help make the

configuration process easier.

Door open time defines the amount of time that the door can remain open after the

door is unlocked, before an alarm is generated by the controller.

For more detailed information on door settings, please refer to the chapter in this

manual entitled “controller functionality and configuration”.

3. Configure the reader settings

Users can configure the following properties of the readers: the reader-to-door

allocation, the keypad reader and the system reader. For the more details about the

reader settings, please refer to chapter 6.

On the EFC-02, readers can be allocated to different doors, and can be set as ENTER

only or EXIT only. So set these properties following the system access control plan.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64

Sin comentarios

EverFocus EBC890 Manual de usuario Pagina 59