EverFocus Flex1.0 Manual de usuario descargar pdf (Pagina 51)

EverFocus Navigation Access Control Management Software

4 Access Rule

4.1 Controller management

This section will introduce how to set the controller. Through this section, you may know:

 How to add, delete and configure controller in the system software.

 How to download data to the controller.

4.1.1 Controller setting

Click “Access Rule” “Controller Management” menu, select “Controller Setting” to enter the

controller management setting page.

The controller setting page is classified into the operating button bar on the top and controller list

bar at the bottom.

 Operating button bar:

The operating button bar includes 8 operating buttons: add, modify, delete, advanced, download,

upload, export and print to perform the operations of adding, modifying, deleting, configuring

controllers.

 Controller list bar:

The controller list bar displays the basic information of the controller such as the RS485 address

of the controller, the online state, serial port occupied, controller type, controller location, door

area quantity, card reader quantity, defence area quantity and the authority group.

!Note: the controller setting is valid only when it is online; the off-line controller is not

allowed to be set.

4.1.2 Add a controller

Click the “Add” button in the operating button bar, then the page of controller adding will pop up,

as shown in the figure below:

Chapter

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 139 140

Sin comentarios

EverFocus Flex1.0 Manual de usuario Pagina 51