EverFocus EFC306 Manual de usuario Pagina 67

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 160
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 66
NAV IP Access controller
58
Press toentertotheaddresssettingmenu,asshownbelow:
5.12Arm/Disarm
Afteranalarmmoduleisinstalled,itdefines10armzonesforits10alarminputs(includingthe2alarm
inputsonmainmodule).NAVControllercantreatalarminputsin10armzonesinaveryflexiblemanner.
These10armzonescanbearmedordisarmedonthecontrollerasdescribedbelow.
5.12.1ArmtheSystemusingtheControllerKeypad
UsermusthavetheARMPINinordertoutilizethisfunction.Pleaserefertothesection“SetARMPIN”in
this chapter for instructions on how to set ARM PIN. After system installation, the date and time
informationwillbedisplayedontheLCD,asshownbelow:
Whenon
the keypad is pressed, the system prompts the user to enter a password, as shown
below:
After entering the password, pressto confirm. The default password is 00000000. Once the
passwordisverified,thecurrentsystemARMstatuswillbedisplayedasshownbelow:
Presstoarmallactivearm
zones.Thefollowingmessageisdisplayed:
Press toexit.Thecontrollerwillwaitfortheperiodoftimedefinedas“alarmdelay”andthenarm
allactivearmzones.
5.12.2DisarmtheSystemusingtheControllerKeypad
Inordertoutilizethisfunction,theusermusthavetheARMPINandthecardmustbeloggedinasARM
enabled. Assuming the system is in armed status, the user swipes the card to access the door. The
controller will disarm all active arm zones in arm delay time.
For example, if the system is in armed
status and a card is presented, the controller will disarm all active arm zones for the amount of time
System Armed
[ENT] to Disarm
System Disarmed
[ENT] to Arm
Password
______
2009-06-18
THU 09:38
Address Setting
0000
Address Setting
Vista de pagina 66
1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 159 160

Comentarios a estos manuales

Sin comentarios