EverFocus ECOR 264-8/4 D2 Manual de usuario descargar pdf (Pagina 86)

Data Bit: This field is the data bit at which you will be transferring. There are two settings for this option: 8

or 7.

Stop Bit: This field is to set the stop bit for the RS232 connection. There are two different stop bits, 1 or 2.

Parity: This field is to select the parity level at which you will be connected. You can choose between

None, Odd, or Even parity levels.

RS485

PTZ Protocol: Select PTZ protocol, choose from the following protocols: Transparent, Pelco D, Pelco P,

Everfocus, or Samsung. (NOTE: all cameras on the bus must use the same protocol)

485 ID: This is the ID used by the EKB500 to send commands to the DVR. On an RS485 connection, every

device (PTZ, DVR and controller) must be assigned a unique ID number between 0 and 127.

Baud Rate: The speed used to transmit instructions or information through the RS485 port on the DVR.

Choose from the following speeds: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200 BPS.

Data Bit: The number of data bits used in a data packet or word. This can be set to 8 or 7.

Stop Bit: This field is to set the number of stop bits indicating the end of a data packet. This can be set to 1

or 2.

Parity: This selects the transmission error checking rule. Choose either None, Odd, or Even.

Control

IR Remote ID: ID used by the remote control to select this DVR.

4.10.5 Misc.

Figure 4-37 System Menu – Firmware & Misc.

Firmware

Current Firmware Version: Displays the current version.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 123 124

Sin comentarios

EverFocus ECOR 264-8/4 D2 Manual de usuario Pagina 86