EverFocus Flex1.0 Manual de usuario Pagina 37

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 123
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 36
setting is used to configure the outputs when a signal from the Fire Alarm input
is activated.
2. To change the “Fire Alarm” setting:
a. Point the mouse over the cell being changed.
b. Double click the mouse to switch the setting from:
Yes to No or vice versa. Yes indicates there is an alarm output (relay
energized) No indicates there is no alarm output (relay not energized).
Double Click
Fig. 4.19 Configure an alarm
3. For the door module alarm configurations under “Alarm setting 3” tab, there is
one difference. A third option is introduced only for the door module alarm
outputs. Follow the steps bellow:
a. Point and click the mouse over the cell being changed.
b. For the door module outputs, an option to select from a menu appears,
follow the steps as below:
Click on the arrow and choose from Y, N or R.
30
Vista de pagina 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 122 123

Comentarios a estos manuales

Sin comentarios