EverFocus Eptz3000 Manual de usuario descargar pdf (Pagina 33)

3-32

can set the masking size and position in the private zone setup mode.

In this mode, you can press

“Shift” + “6” to increase masking horizontal size;

“Shift” + “4” to decrease masking horizontal size;

“Shift” + “2” to increase masking vertical size;

“Shift” + “8” to decrease masking vertical size;

Shift Joystick to select the position where the masking is located.

“Enter” to confirm the size and position, and then the masking will turn into green again.

18. AUTO REGRESS：Auto regress to the shortest path during set a position. It can

shorten the response delay, and increase the response performance and speed dome

lifetime.

ON: Enable the auto regress function.

OFF: Disable the auto regress function.

19. X CNT： X-axis counter. This counter counts the x axis movement, and 1 is counted

when the speed dome pans 360°.

20. Y CNT： Y-axis counter. This counter counts the y axis movement, and 1 is counted

when the speed dome tilts 180°.

21. PO CNT： Position counter. This counter counts the go-position times, 1 is counted

when speed dome goes to a position once.

22. OP HR： Operation hour. This counter counts the operation hours.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39

Sin comentarios

EverFocus Eptz3000 Manual de usuario Pagina 33