EverFocus Eptz3000 Manual de usuario descargar pdf (Pagina 15)

2-14

2.3.1. Address Setting

The address code of the EPTZ3000/EPTZ3000I should be set to correspond

properly with a control device to control multiple dome cameras. The address codes

are made up by the dipswitch SW1 (8 bits) on the PCB board. The 8 bits dipswitch

indicates the binary coded of the address, and there are 256 addresses can be

selected (0 ~ 255, 2

= 256). It also means that there are up to 256 dome cameras that

can cascade on the RS-485 bus. The dipswitch setting and the indicated address are

represented in the following chart.

Note: The factory default address is 1.

Notice: Please make sure the power is off before setting, and restart the

EPTZ3000/EPTZ3000I to enable a new value after changing.

SW1

12345678

CPU

12345678

SW2

ID1

ID2

ID3

ID4

ID5

ID6

ID7

ID8

Protocol

BAUD

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 38 39

Sin comentarios

EverFocus Eptz3000 Manual de usuario Pagina 15