EverFocus EDVR 16D1 Manual de instrucciones descargar pdf (Pagina 87)

7777

9. Upgrade Firmware

This chapter will try to give you a detailed instruction on how to upgrade the DVR. This

will be helpful in completing the upgrading process.

1. Copy the .ETW file to your USB pocket drive from your computer.

2. Insert the USB pocket drive in to the top USB slot on the front panel of the DVR. When

inserting the USB, make sure the direction of insertion is correct.

3. If you are in Record mode hit the STOP button to stop recording first (before entering

the Menu).

4. If it cannot stop recording after pressing STOP button, please enter Schedule Setup

Menu and turn all schedules off, then exit completely from Menu.

5. Once you have stopped any type of recording on the DVR you are ready to upgrade.

6. Press the MENU button and use the Jog Dial to go to “System” menu.

7. Press ENTER until “System Upgrade” is highlighted, then change NO to YES using

the Jog wheel.

8. Choose “YES” again and press SELECT to confirm.

9. You will see "Updating 1/3" at the bottom-left of the screen. Status will progress

from 1/3 -> 2/3 -> 3/3.

10. Once the message “Success, Please Reboot” pops up, highlight “Load/Save

Configuration and change it from NO to YES.

11. Select DEFAULT and press SELECT.

12. When you see “Success” at the bottom of the screen, press the menu button twice

to log out of the menu and remove USB pocket drive. Then turn the DVR’s power

off, wait 3 seconds, and turn it back on.

13. After the system reboots, you can check the current version by going back to

“System” menu.

Chapter

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 154 155

Sin comentarios

EverFocus EDVR 16D1 Manual de instrucciones Pagina 87