EverFocus EDVR 16D1 Manual de instrucciones descargar pdf (Pagina 39)

2929

3. LOG

YES: Select YES if you wish to record Alarm Events in the Log.

NO: Select NO if you do not wish to record Alarm Events in the Log.

4. ACTIVE CAMERA

This field is to activate camera you want to have the alarm enabled too. For example if

you had an external motion detector on camera one you would set this option to camera

one. The Default setting is the same camera number as the current alarm. To change

this, simply use the Jog Dial on the DVR.

5. PTZ PRESET

Select PTZ PRESET from “001” to “255”, so that when Alarm occurs, speed dome will

turn to this preset position for event recording. This function improves surveillance

quality of an alarm event. If you wish to disable this function, simply select “OFF”.

6. DURATION

1~99 SEC: The amount of time alarm recording, screen change, buzzer and output

contact will last. Adjustable from 1 ~ 99 seconds.

TRANSPARENT: Continuous recording, screen change, buzzer, and output contact

for an alarm event.

7. ALARM OUTPUT

This will transmit a signal to another device. The setting of alarms are NONE = not

activated, 1 = output signal 1 transmits, 2 = output signal 2 transmits, 3 = output

signal 3 transmits and 4 = output signal 4 transmits.

Note: For D1 and D2 series, only 1 alarm output is available. For D3 series, there are 4

alarm outputs total.

8. ALARM EMAIL

Select “YES” for sending an email when alarm occurs or “NO” to disable alarm email.

The email address can be set in the NETWORK SETUP MENU.

9. BUZZER: Audible alarm buzzer.

ENABLE: To enable the alarm buzzer.

DISABLE: To disable the alarm buzzer.

10. ALARM NETWORK

YES: Enable alarm network.

NO: Disable alarm network.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 154 155

Sin comentarios

EverFocus EDVR 16D1 Manual de instrucciones Pagina 39