EverFocus EAN Plus Series Manual de usuario descargar pdf (Pagina 12)

EAN Plus Series

4.2 I/O Terminal Block

The I/O terminal block, located on the rear panel of the camera, can be used to develop application

for alarm input and output.

1 2 3 4

Pin Assignment

No. Function No. Function

1 Alarm COM 3 Alarm Input

2 Alarm Output 4 Digital GND

4.3 Lens Installation and Adjustment

You can install either a CS-mount or a C-mount lens into the camera. It is recommended to use a lens

with aperture ratio of F/1.4 or smaller. Please refer to the following reference steps.

C-Mount Lens Adapter

DC Auto Iris Lens Connector

Focus Screw

Zoom Screw

CS-Mount Lens:

1. Remove the cover cap from the camera body.

2. Install the lens into the camera body.

3. Adjust the lens using the Focus / Zoom Screws.

If you are using a DC Auto Iris lens:

1. Remove the cover cap from the camera body.

2. Install the lens into the camera body.

3. Connect the DC cable to the DC Auto Iris Lens Connector.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 75 76

Sin comentarios

EverFocus EAN Plus Series Manual de usuario Pagina 12