EverFocus EHN Series Guía de instalación

EHN Plus Series Outdoor Vandal Proof IP Dome Camera

EHN Plus Series 9 f. Due to the variable cable diameters, for better waterproofing, it is strongly recommended that you apply sil

EHN Plus Series 10 12. Access the camera live view for adjusting camera lens and angles. For details on how to access the camera l

EHN Plus Series 11 3.1 Adjustment Rings The four Adjustment Rings, including one black and three transparent rings, attached on t

EHN Plus Series 12 4. Accessing the Camera You have to assign an IP address for your camera to be accessible. To assign an IP addr

EHN Plus Series 13 5. To change the IP address, double-click the IP Address of the camera. Type a new IP address and then click S

EHN Plus Series 14 5. Connecting to the Network You can use one of the methods below to connect the camera to the network. Router

EHN Plus Series 15 Direct High-Speed Connection In a Direct High-Speed Connection, the camera connects directly to a modem without

EHN Plus Series 16 6. Upgrading Firmware You can upgrade camera’s firmware using the IP Utility software, which is included in the

EverFocus Electronics Corp. EverFocus Taiwan: 12F, No.79, Sec. 1, Shin-Tai Wu

EHN Plus Series 1 1. Overview The EHN Plus series vandal proof IP dome Camera is designed f

EHN Plus Series 2 System Requirement Before installing, please check that your computer meets this system requirement. • Operatin

EHN Plus Series 3 2. Terminal Block The I/O terminal block, located on the camera module, can be used to develop applications for

EHN Plus Series 4 3. Installation Important Notice for the Installation If you want to mount the camera on the wall where direct s

EHN Plus Series 5 2. Unscrew the four screws and remove the Base Plate from the Camera Case. Camera CaseBase Plate 3. Unscrew

EHN Plus Series 6 If you want to wire the cables through the bottom of the Camera Case, follow the steps below: a. Remove the Cir

EHN Plus Series 7 d. Screw Adapter Plate between the Base Plate and Wiring Box. Base PlateWiring BoxAdapter Plate 5. Screw th

EHN Plus Series 8 • Transparent x 3 (1 mm thickness) • Black x 1 (0.5 mm thickness) b. Remove the Plug(s) from