EverFocus ECOR264-D2 guide Manual de usuario descargar pdf (Pagina 91)

4.10 SYSTEM SETTING

Figure 4-31 is a screenshot of the SYSTEM SETTING MENU. This menu is for setting up the general

system parameters for the DVR.

Figure 4-33 System Menu – Date/Time

4.10.1 Date/Time

Date: Set current Date.

Time: Set current Time.

Date Format: Choose date format from yyyy/mm/dd, dd/mm/yyyy, and mm/dd/yyyy.

Time Format: Change time format between 12H and 24H mode.

Time Zone: Set the time zone that the DVR adjusts to when updating from the time server.

NTP: Select “Enable” or “Disable” NTP time synchronization.

NTP Server: Displays the time server address that the DVR uses for time synchronization. Requires

operating network configuration and WAN or LAN access to a compatible NTP server.

To find a compatible NTP address, please follow these steps:

a) Go to a PC that is connected to the internet.

b) Click on “START” -> “RUN” -> type “command” and press “OK”.

c) In the DOS Prompt, type “ping pool.ntp.org” to find out the IP address of an NTP Server.

NTP Update Interval: The frequency that the system automatically updates the time via the NTP server.

Select Daily, Weekly, or Monthly.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 139 140

Sin comentarios

EverFocus ECOR264-D2 guide Manual de usuario Pagina 91