EverFocus EDN Plus Series Guía de instalación

EDN Plus Series Indoor IP Dome Camera Quick Inst

EDN Plus Series 9 5. To change the IP address, double-click the IP Address of the camera. Type a new IP address and then click Se

EDN Plus Series 10 5. Network Connections You can use one of the methods below to connect the camera to the network. Router or LA

EDN Plus Series 11 Direct High-Speed Connection In a Direct High-Speed Connection, the camera connects directly to a modem without

EDN Plus Series 12 6. Upgrading Firmware You can upgrade camera’s firmware using the IP Utility software, which is included in the

EverFocus Electronics Corp. EverFocus Taiwan: 12F, No.79, Sec. 1, Shin-Tai Wu

EDN Plus Series 1 1. Overview The EDN Plus series IP dome is designed for indoor use. The s

EDN Plus Series 2 System Requirement Before installing, please check that your computer meets this system requirement. • Operatin

EDN Plus Series 3 3. Installation There are two ways to mount the EDN Plus IP Dome: Wall-Surface Mount and In-Ceiling Mount. Wa

EDN Plus Series 4 4. Unscrew the three screws and take out the camera body. 5. Thread the cables on the side of the camera case

EDN Plus Series 5 8. Place and screw the camera body back to the camera case. 9. Connect the network, power and other cable

EDN Plus Series 6 Rotational Adjustment: Using the rotate screw. 180° Tilt Adjustment: Using the two tilt screws. 64° 13. Secure

EDN Plus Series 7 4. On the back side, make sure the black plastic clips are slightly above the ceiling board and pointing outwar

EDN Plus Series 8 4. Accessing the Camera You have to assign an IP address for your camera to be accessible. To assign an IP addre