EverFocus EHD650 Especificaciones

Busca en linea o descarga Especificaciones para Cámaras De Seguridad EverFocus EHD650. EverFocus EHD650 Specifications Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 25
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
EVERFOCUS
1/3” Wide-Dynamic
True D/N Rugged Dome Color Camera
Operation Instructions
Model No. EHD650
Please read this manual first for correct installation and operation. This manual should be retained
for future reference. The information in this manual was current when published. The
manufacturer reserves the right to revise and improve its products. All specifications are therefore
subject to change without notice.
PRECAUTIONS
1. Do not install the camera near electric or magnetic fields.
Install the camera away from TV, radio transmitter, magnet, electric motor, transformer,
audio speakers since the magnetic fields generate from above devices will distort the video
image.
2. Never disassemble the camera nor put impurities in it.
Disassembly or impurities may result in trouble or fire.
3. Never face the camera toward the sun.
Direct sunlight or severe ray may cause fatal damage to sensor and internal circuit.
4. Keep the power cord away from wet and never touch the power cord with wet hands.
Touching the wet power cord with hands or touching the power cord with wet hands may
result in electric shock.
5. Never install the camera in areas exposed to water, oil or gas.
Water, oil or gas may result in failure, electric shock or file.
6. Cleaning
Do not touch the surface of sensor by hand directly. Use a soft cloth to remove the dirt from
the camera body. Use lens tissue or a cotton tipped applicator and ethanol to clean the sensor
and the camera lens.
7. Do not operate the camera beyond the specified temperature, humidity or power source
ratings.
Use the camera at temperatures within -40 ~ 50 (-40~122) and humidity between
20%~80%. The input power source is 24VAC .
Vista de pagina 0
1 2 3 4 5 6 ... 24 25

Indice de contenidos

Pagina 1 - EVERFOCUS

EVERFOCUS 1/3” Wide-Dynamic True D/N Rugged Dome Color Camera Operation Instructions Model No. EHD650 Please read this manual first for correct ins

Pagina 2 - TABLE OF CONTENTS

- 10 - d. Tighten fixing screws and finished 2.2 Mounting Cameras on the Ceiling/Wall a. Mount the base to the wall or ceiling, fix the base by th

Pagina 3 - 1.1 Main Features

- 11 - b. Take off cable conduit if you need to wire cable through side conduit hole. The camera comes with a conduit plug pre-installed in the PF 1/2

Pagina 4 - OPTIONAL ACCESSORIES

- 12 - b. Connect cable conduit to the conduit hole and make it tight. c. Connect the power supply cable (24VAC), video output to the prope

Pagina 5 - 1.3 Specifications

- 13 - e. Optional connect to Alarm(Please see figure 8 for terminal functions) f. V. Phase adjustment screw is located on the termin

Pagina 6

- 14 - 2.4 Adjust Lens zoom and focus and View a. Adjust Lens zoom and focus(for vari-focal lens models) b.

Pagina 7

- 15 - 3. HOW TO CONTROL OSD MENU 3.1 Where is OSD Controller Detach the mini-joystick on the side of camera housing. See the following picture.

Pagina 8

- 16 - I. Press the SET button for 3 seconds The menu screen will appear on the monitor as the block shown above. II. Using the cursor button Use

Pagina 9

- 17 - 4. MAIN MENU 4.1 Setup ID Camera Menu: Display ID/Camera ID/ID position DISPLAY ID: ON/OFF. The camera ID can be displayed on

Pagina 10 - Figure 3-4

- 18 - ID POSITION: UP-LEFT / UP-CENTER / UP-RIGHT / DWN-LEFT / DWN-CENTER / DWN-RIGHT There are four positions can be chosen to show the CAMERA I

Pagina 11

- 19 - 4.3 WDR (Wide Dynamic Range) EXPO BIAS: MIN -18 ~ 18 MAX Select exposure bias from min. -18 to max. 18. WDR BIAS: MIN –20 ~ 20 MAX The

Pagina 12 - Figure 6-3

- 2 - TABLE OF CONTENTS 1. PRODUCT OVERVIEW ...

Pagina 13 - V. Phase Adjustment VR

- 20 - WB CONTROL: ATW ATW (Auto Tracking White Balance): This mode can be used within the color temperature range from 2,500°K to 9,500°K (eg, fluo

Pagina 14

- 21 - AGC MENU: SET LEVEL from MIN –34 to MAX 43. The more the level of gain increases, the brighter the screen and the level of noise i

Pagina 15 - 3. HOW TO CONTROL OSD MENU

- 22 - 4.7 SYNC SYNC: INTERNAL/LINELOCK SYNC-INTERNAL Internal synchronization. SYNC – LINELOCK Phase adjustment may be neces

Pagina 16

- 23 - 4.8 Day/Night Auto/COLOR/B/W DAY/NIGHT: Auto. For automatic switch between day and night mode. C->B 20~35 B->C 0~10

Pagina 17 - 4.1 Setup ID

- 24 - SAVE RESTORE EXIT: RESTORE FACTORY SETTING RESTORE FACTORY SETTING: you will be asked “Are you sure?” before you restore all set

Pagina 18 - 4.2 Lens

- 25 - EverFocus Electronics Corp. Head Office: 12F, No.79 Sec. 1 Shin-Tai Wu Road, Hsi-Chih, Taipei, Taiwan TEL: +886-2-26982334 FAX: +886-2-2698

Pagina 19 - 4.4 WB Control

- 3 - 1. PRODUCT OVERVIEW The most technically advanced EHD650 is the newest vandal-resistant Color Rugged Dome Camera from EverFocus Electronics. Th

Pagina 20 - 4. 5 AGC

- 4 - 1.2 Package Contents z Camera Unit x 1 z Mounting Accessory includes: - Screws x 4 - Expanding Screws x 4 - Wrench x 1 z Weather-proo

Pagina 21 - 4.6 Low Light

- 5 - 1.3 Specifications Pickup Device 1/3'' DPS Wide Dynamic range sensor Video Format NTSC or PAL Scanning System NTSC: 525 TV lines, 60 f

Pagina 22 - 4.7 SYNC

- 6 - 1.4 Dimensions a. b.

Pagina 23 - 4.9 Exit Menu

- 7 - 1.5 Hardware Overview Conduit plug setscrew Side conduit hole Back conduit hole Mounting Setscrew Mounting Setscre

Pagina 24

- 8 - 2. INSTALLATION This section covers simple steps and detail installation. Please follow instruction for preventing any unnecessary damage. Simp

Pagina 25 - EverFocus Electronics Corp

- 9 - To remove the camera, first unplug the wire connection on the back of the camera. Then loosen the 2 locking screws on the camera base, push the

Comentarios a estos manuales

Sin comentarios