EverFocus ECOR 264x1-4 Manual de instrucciones descargar pdf (Pagina 93)

Default: 9600

Data Bit Data bit used for transmission, select 7 or 8

Default: 8

Stop Bit Stop bit used for transmission, select 1 or 2

Default: 1

Parity Parity setting for RS-485 transmission, select NONE, ODD or EVEN

Default: NONE

CONTROL

IR Remote ID Receiver ID for IR - remote control. Select 1~4.

One remote control can be used to operate up to 4 DVRs. The DVR to be addressed is

selected by pressing the key corresponding to its ID number on the remote control.

4.10.5 Misc.

Figure 4-41 System Menu – Firmware & Misc.

Firmware

Current Firmware Version Displays the current version.

Firmware Upgrade Press “Upgrade” to upgrade the firmware.

NOTE To perform a Firmware Upgrade, you will need to connect a

USB flash device with the latest version of the firmware. Do not

disconnect the USB device or turn off the power to the unit during

the upgrade; this can cause the system to fail to recover, requiring

factory service to repair.

Configurations

Load Factory Default Click “Load” to restore all menu settings to the default values. User

Account, Network Setting, and Time are not affected.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 127 128

Sin comentarios

EverFocus ECOR 264x1-4 Manual de instrucciones Pagina 93