EverFocus ECOR 264x1-4 Manual de instrucciones descargar pdf (Pagina 31)

3.6 PTZ

3.6.1 PTZ control panel

If the connected camera is defined as a PTZ device (Speed Dome, PTZ head with RS-485 receiver), the

PTZ control panel is shown at left side after clicking on

button.

Required settings: 1. PTZ is enabled and RS-485 address is entered in CAMERA > BASIC SETTING.

2. RS-485 parameter are adjusted in SYSTEM > I/O CONTROL

Go to Preset Position

PRESET > [number] > GO

Save Preset Position

PRESET > [number] > SET

Delete Preset Position

PRESET > [number] > DELETE

Start Preset Tour

TOUR > [number] > GO

Start Pattern

PATTERN

Note: The PATTERN commands vary depending on dome model

/manufacturer. Please consult documentation of the speed dome for details.

Start Auto-Pan

AUTO-PAN

Open Setup Menu

PRESET > [95] > SET

Enter in Speed Dome OSD

I+ ((iris open)

ESC / Cancel in Speed Dome OSD

I- (Iris close)

Pan / Tilt direction keys

Zoom in (+), Zoom out (-)

Focus far (+), Focus near (-)

Iris open (+), Iris close (-)

Input field for preset, tour and pattern numbers

Number buttons

Clear numeric input

Start (for preset, tour, pattern)

Save preset position

Delete preset position

Auto-Pan

Preset position

Preset Tour

Pattern

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 127 128

Sin comentarios

EverFocus ECOR 264x1-4 Manual de instrucciones Pagina 31