EverFocus EDSR400M Manual de instrucciones descargar pdf (Pagina 19)

VIDEO IN (1~4): The BNC connectors of video input enables the system to receive the signals from

each camera through the 75 ohm coaxial cables.

VIDEO IN /Output

VIDEO OUT(1~4) : Connect the other devices with four cameras to the other devices.

MAIN MONITOR : This connector is used for the Main monitor display, A number ofdifferent

display modes may be selected for viewing.

MAIN

MONITOR

MONITOR OUT

INTERNAL

VIDEO

SW3

When the machine is in Menu, Search or Copy mode, the internal Video is switched to Monitor Out, so that the user

can view full screen OSD. In other modes, the Video from multiplexer main monitor will be loop-through to the Monitor

Out.

MONITOR

Back Panel Connections

( Internal circuit )

CALL MONITOR : This connector is used for the Call(secondary) monitor. This monitor can only

display full screen.

ALM-OUTPUT : Normal Close Alarm output. In normal condition, this terminal is

shorted to the terminal of ALM -COM. In alarm status, it is open

between ALM-NC and ALM-COM terminals.

ALM-INPUT : Normal Open or Normal Close type alarm sensor input.

The Alarm Input can be selected as Normal Open or Normal Close input in the setup

menu. When an alarm occurs, alarm recording will automatically start.

Alarm Input/ Output

Alarm Input

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 71 72

Sin comentarios

EverFocus EDSR400M Manual de instrucciones Pagina 19