EverFocus EPTZ Series Manual de usuario descargar pdf (Pagina 14)

2-13

2.3.2. Communication Protocol Setting

The 1

, 2

and 3

bits of the SW2 are used to set communication protocol. The factory

default protocol is EVF-1.

12345678

SW2

Protocol

Baud Rate

PAL / NTSC

Maching Resistance

12345678

EVF - 1

12345678

PELCO-D

12345678

PELCO-P

Notice: Please make sure the power is off before setting, and restart the EPTZ1000 to

enable a new value after changing.

Set all of protocol switches to ON; the speed EPTZ1000 will enter a self-test mode.

2.3.3. Transmission Speed Setting (Baud Rate Setting)

The 4

and 5

bits of the SW2 on the PCB board are used to set the Baud Rate. The

default baud rate setting is 9600.

12345678

SW2

Protocol

Baud Rate

PAL / NTSC

Maching Resistance

12345678

9600 BPS 4800 BPS 2400 BPS

12345678

1200 BPS

12345678

Notice: Please make sure the power is off before setting, and restart the EPTZ1000 to

enable a new value after changing.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Sin comentarios

EverFocus EPTZ Series Manual de usuario Pagina 14