EverFocus EHD150 Manual de usuario

11//33”” BB//WW RRuuggggeedd DDoommee CCaammeerraa User’s Manual and Operation Instructions

5. View Angel Adjustment The camera can be rotated 360°horizontally, and the vertical view angle is 140°(as shown in Figure 7). Adjust the proper c

LL (Line-Lock) Off/On To select the sync mode between Internal Sync.(LL off) and Line-Lock (LL on). Set the line-lock off, the camera

BLC (Back Light Compensation) On/Normal When BLC is turned on, the AGC, ES and IRIS operating point is determined by averaging over the center area i

IRIS Level Adjustment Brightness Level can be adjusted from the IRIS level VR while using the direct drive lens. ? Turn counterclockwise to L to get

USA Office: 2445 Huntington Drive, San Marino, CA, 91108 U.S.A. TEL: 1-626-844-8888 FAX: 1-626-844-8838 Toll free: 1-888-383-6287

Notice This manual is presented to the users of EHD150 by EverFocus Electronics Corp. With years of engineering researches, EverFocus has sp

Table of Contents Safety Warning …………………………………………1 Introduction……………………………………………..2 Specification…………………

1. Do not install the camera near electric or magnetic fields. Installed the camera away from TV, radio transmitter, magnet, electric motor,

The most technically advanced EHD150 is the newest vandal-resistant B/W Rugged Dome Camera from EverFocus Electronics. The B/W Rugged Dome Camera

Specification Pickup device: 1/3” interline transfer CCD Picture element: NTSC :768(H) × 49

1. Loosen the 4 fix screws on the housing cover by using the attached wrench (Figure 1). Carefully uncap the housing cover as the direction shown be

3. Mounting the base. Attach the base to the wall or ceiling, fix the base by the 4 setscrews attached in the accessory pack. The dome i

4. Wire Connection Connect the power supply cable (AC24V/DC12V), video output and alarm output to the proper connectors shown as Figure