EverFocus EDN Series Guía de instalación

EDN Series Indoor IP Dome Camera Quick Installat

EDN Series 9 5. To change the IP setting, double-click the values in the column and type the numbers or select an option. Click S

EDN Series 10 5. Network Connections You can use one of the methods below to connect the camera to the network. Router or LAN Con

EDN Series 11 Direct High-Speed Connection In a Direct High-Speed Connection, the camera connects directly to a modem without the

EDN Series 12 6. Upgrading Firmware You can upgrade camera’s firmware using the IP Utility software, which is included in the soft

EverFocus Electronics Corp. EverFocus Taiwan: 12F, No.79, Sec. 1, Shin-Tai Wu

EDN Series 1 1. Overview The EDN series IP dome is designed for indoor use. The series come

EDN Series 2 System Requirement Before installing, please check that your computer meets this system requirement. • Operating Sys

EDN Series 3 3. Installation There are two ways to mount the EDN IP Dome: Wall-Surface Mount and In-Ceiling Mount. Wall-Surface

EDN Series 4 4. Unscrew the three screws and take out the camera body. 5. Thread the cables on the side of the camera case. If

EDN Series 5 8. Place and screw the camera body back to the camera case. 9. Connect the network, power and other cables to

EDN Series 6 Rotational Adjustment: Using the rotate screw. 180° Tilt Adjustment: Using the two tilt screws. 64° 13. Secure the

EDN Series 7 4. On the back side, make sure the black plastic clips are slightly above the ceiling board and pointing outward.

EDN Series 8 4. Accessing the Camera You can look up the IP address and access the Web interface of the camera using the IP Utilit