EverFocus EMV800 Manual de usuario descargar pdf (Pagina 54)

Alarm: Select the alarm input trigger connection number from 1 to 12 (or 1 to 8).

Enable: Check box to enable response to that alarm trigger.

Input Type: This field is to change the type of alarm trigger.

N.O.: Normal Open contact.

N.C.: Normal Closed contact.

Display Switch: Select which channel to be displayed when alarm is triggered. Available options are

CH1~12 (CH1~8), Quad 1, Quad 3 and Quad 3.

Alarm Output: This will transmit a signal through the alarm output. It can be set to either “NONE” (not

active), “1” or “2” (selects alarm relay to be active).

Output Type: Output action when alarm is triggered.

Timeout: Alarm output lasts for the set time duration.

Permanent: Alarm will remain active until the user presses the “Enter” key or resets the alarm remotely.

Transparent: Alarm output remains as long as the alarm input is active.

Trans+Timeout: Alarm output continues until event ends, then continues for the set time duration.

Timeout Duration: Time duration selectable from 1 to 150 seconds.

Pre-alarm Record: Check box to start copying recorded video to the hard disk from 5 seconds before the

alarm event. (Pre-alarm recording rate will follow the “Normal” frame rate setting)

Buzzer: Check this box to enable the buzzer when an alarm occurs.

Email: Check box to enable email notification when an alarm occurs. Email operation requires that valid

email settings have been entered in the Network Setting/Email setup screen. (See Section 4.7.4 Email for

more information.)

Network Alarm: Check this box to send out a network alarm to a client PC when motion occurs. (This

feature requires PowerCon software on the client PC and proper settings for the Alarm Server in the

Network Setup menu; see Section 4.7.6 Alarm Server for more information.)

Click

button to return to the previous level of menu.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 136 137

Sin comentarios

EverFocus EMV800 Manual de usuario Pagina 54