EverFocus PowerVideo Plus Manual de usuario descargar pdf (Pagina 114)

EPHD04+ HDcctv DVR

106

RS-485

PTZ Protocol: Select PTZ protocol, choose from the following protocols: Transparent, Pelco D,

Pelco P, or Everfocus. (Note: All cameras on the RS-485 bus must use the same protocol)

485 ID: This is the ID used by the EKB500 to send commands to the DVR. On an RS-485

connection, every device (PTZ, DVR and controller) must be assigned an unique ID number

between 0 and 127.

Baud Rate: This field is to set the speed at which is used to transmit instruction or

information through the RS-485 port on the DVR. There are eight different speeds: 1200 BPS,

2400 BPS, 4800 BPS, 9600 BPS, 19200 BPS, 38400 BPS, 57600 BPS and 115200 BPS.

Data Bit: This field is the data bit at which you will be transferring. There are two settings for

this option: 8 or 7.

Stop Bit: This field is to set the stop bit for the RS232 connection. There are two different stop

bits, 1 or 2.

Parity: This field is to select the parity level at which you will be connected. You can choose

between None, Odd, or Even parity levels.

Control: One remote control can be used to operate four DVRs. The DVR to be addressed is

selected by pressing the key corresponding to its ID number on the IR Remote control. Please

refer to Appendix E: IR Remote Control.

IR Controller ID: Set up an ID for the DVR and allow the IR remote control to control this DVR.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 145 146

Sin comentarios

EverFocus PowerVideo Plus Manual de usuario Pagina 114