EverFocus 3TB Paragon 16 Manual de instrucciones Pagina 54

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 127
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 53
47
No change: No change on the call monitor display.
Full screen: A full screen of the active camera will display on the call monitor.
Pre-alarm Record: Check box to record several moments before the motion event. (Pre-alarm recording
rate will follow “Normal” frame rate setting)
Buzzer: Check box to enable buzzer when a motion event is triggered.
Email Notify: Check box to send email notification when a motion event is detected.
Network Alarm: Check box to send out a network alarm to client PC when motion occurs. (requires
PowerCon software and setting up Alarm Server in Network Setup menu)
Auto Lock: Check the box and the events will be recorded to the write protected segment of the Hard Disk.
Alarm Output: This will transmit a signal through one of the alarm outputs. It can be set to either NONE
(not active), “1”, “2”, “3”, or “4”.
Output Type: Output action when motion is triggered.
Timeout: Alarm output lasts for a set time duration.
Permanent: Alarm will remain on until user presses “Enter” key on front panel.
Transparent: Alarm output continues as long as there is a motion event.
Trans+Timeout: Alarm output continues until event ends, then lasts for the set time duration.
Timeout Duration: Time duration selectable from 1 to150 seconds.
Edit Motion Grid: Press this button to edit the motion grid (See Figure 5-5 Camera Menu – Motion Grid Setting ).
Sensitivity: Set the threshold value for sensitivity. Select from 1 (lowest) to 10 (highest).
Min Area: To avoid false detections by small objects, this value defines how many grids have to be
triggered to generate a motion event. Select a value between 1 (default) to 5 grids.
Delay: Filter function for avoiding false alarms (set to 1 for the easiest trigger)
Preview: Turn off display for motion grid
Set All: Press this button to select the entire area.
Clear All: Press this button to clear the entire grid.
Save & Back: Press this button to save the motion grid setting and return to motion setting menu.
Cancel: Press this button to cancel all changes and return to motion setting menu.
How to select motion grid by mouse:
1. Select upper-left corner of area
2. Select lower-right corner of area
3. The area between corners will be selected.
Vista de pagina 53
1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 126 127

Comentarios a estos manuales

Sin comentarios